Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - enbe11_3

Pages: 1 [2]
16
Support / Re: JPCT Requirements
« on: November 01, 2009, 01:56:38 am »
OLPC don't have a compatible graphics hardware, but my idea is to make 3d applications with
the jPCT 3d software rendering.

There's only one problem(i think). -The bare minimum for simpler applications is a 450Mhz cpu - (http://www.jpct.net/requirements.html) and OLPC cpu is an AMD Geode LX 700 - 433mhz  :-[...

is it possible to run a jPCT simpler application in a 433mhz cpu?  ???

thanks!

(sorry for my bad english)


17
Support / JPCT Requirements
« on: October 31, 2009, 03:46:12 pm »

HI,
   I was wondering if JPCT could run in a OLPC... ?

OLPC hardware:

CPU: AMD Geode LX-700 - x86-compatible processor with 64KB each L1 I and D cache; at least 128KB L2 cache; AMD Geode LX-700@0.8W;

CPU clock speed: 433 Mhz;

ISA compatibility: Support for both the MMX and 3DNow! x86 instruction-set extensions; Athlon instruction set (including MMX and 3DNow! Enhanced) with additional Geode-specific instructions;

Companion chips: PCI and memory interface integrated with CPU; North Bridge: PCI and Memory Interface integrated with Geode CPU; AMD CS5536 South Bridge (datasheet);

Graphics controller: Integrated with Geode CPU; unified memory architecture;

Embedded controller: ENE KB3700 or ENE KB3700B;

DRAM memory: 256 MiB dynamic RAM;

Data rate: Dual — DDR333 — 166 Mhz;

1024KB SPI-interface flash ROM;

Mass storage: 1024 MiB SLC NAND flash, high-speed flash controller;

Drives: No rotating media;

                        (http://laptop.org/en/laptop/)


                           Thanks,

Pages: 1 [2]