Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - masonhsiung

Pages: [1]
1
Support / Re: Vuforia + jPCT-AE
« on: February 07, 2013, 12:00:44 pm »
Got it! thanks! I didn't notice that part :)
Thanks!

2
Support / Re: Vuforia + jPCT-AE
« on: February 07, 2013, 11:25:12 am »
Hi, thanks! After removing these two lines, it looks quite ok now.
Thanks!

BTW, since we do still need to translate by Z axis, according to the 3D object size.
If we load some existing models(eg. md2, obj.. etc), how do we get the size of the 3D object? so that we can place the 3D object exactly on the target.

Thanks again!

regards,
Mason Hsiung

3
Support / Re: Vuforia + jPCT-AE
« on: February 07, 2013, 05:04:53 am »
Hi, here are the plane screenshots(one is from front, another is from right, and it seems that I don't need to rotate 90 deg.).
I think the result is the same with the cube...

Any idea?

Thanks!

regards,
Mason Hsiung

[attachment deleted by admin]

4
Support / Re: Vuforia + jPCT-AE
« on: February 06, 2013, 11:17:54 am »
Hi,
I've followed this wiki instruction.
3D object can be rendered successfully, but it seems that the object is kind of floating/rotating while moving the target, is not perfectly sticked on the target(not like the teapot sample).

I also followed the last part, to translate the object 30 units(I'm using HelloWorld sample, which is using a Cube.) along with the Z-axis, but it didn't help.

Image targets sample screenshot is attached. ( as you can see, the 3D object is not sticked on the center of target)

Any idea?

Thanks!

regards,
Mason Hsiung

[attachment deleted by admin]

Pages: [1]